Installation

Refer to the sections below to install the USB 3.2 Data Matrix Switcher.

In the Box

Qty. Description
1

USB 3.2 Data Matrix Switcher
   
  Additional Items
4 Screw, 4-40 x 1/4 in., Phillips, Black (2007158)
4 Screw, 6-32 x 3/4 in., Truss, Combo, Zinc (2009211)
2 Metal mounting bracket, Black (2057072)
4 Plastic anchor (2043585)
1 3-pin connector (2003575)
4 Washer, Zinc (2007664)
1 24VDC power pack, PW-2440RU (2057005)
1 Power cord (2042043)

Mount the Device

The USB 3.2 Data Matrix Switcher can be mounted to a flat surface. Follow the instructions below.

  1. Using the included 1/4 in. screws, attach the included mounting brackets to the device.

  2. Using the included washers, anchors, and 3/4 in. screws, mount the device to a flat surface.

Connect the Device

Make connections to the USB 3.2 Data Matrix Switcher as shown below.

USB-SW-200 Connections

Front Panel

Rear Panel

USB-SW-400 Connections

Front Panel

Rear Panel

Observe the LED Indicators

Refer to the following table for information about the LED indicators.

LED Indicator Color Meaning
PWR

Amber

 Power is being applied to the device. The device is booting.
Green Power is being applied to the device. The device is operational.
SETUP Red The setup button is pressed.
AUTO Green Auto route mode is enabled.

HOST

Amber

 A host is detected but not routed.
Green A host is selected or routed to one or more devices.

Reset the Device

A factory restore may be performed when troubleshooting to restore all factory default settings on the device.

CAUTION: These procedures should only be performed as a last resort to recover an unresponsive device. The factory restore procedure will clear certain device settings that cannot be recovered once the procedure is complete. Before performing this procedure, please contact Crestron True Blue Support via phone, email or chat as described at www.crestron.com/support.

To restore the device to factory default settings:

  1. Turn off the device by disconnecting the power cable from the device.

  2. Press and hold the SETUP button and then reconnect the power cable while still holding the SETUP button. Continue holding the SETUP button for up to 30 seconds until the SETUP LED flashes.